Gooseneck Specifications

Standard | Optional

Standard Specifications Optional Specifications
Length 20’ – 40’ Length
Width 7’ Width 6’ 8”, 7’ 6”, 8’, 8’ 6”
Height 6’ 6” Height 7’, 7’ 6”, 8”
Nose Configuration ·        4’ Taper

·        3003 Aluminum – 0.100 Thick

o   Welded to Side Posts NOT Riveted

 Nose Configuration ·        Vee Nose

·        Full Width

·        Black, White, Stainless Overlays
Center Gate ·        One (1) w/ Swing Walk Thru Door

·        Hold Up Blocks – Open & Shut Positions

·        HD Slam Latch – Cast Aluminum

·        Outside Slam Latch Release Handle

·        Four (4) HD Extruded Hinges w/ Replaceable Brass Bushings and Stainless Steel Bolt

 Center Gate ·        Two (2) or Three (3) Gates

·        Slider Door

·        Air Gaps per Customer’s Request

·        Lo Pro Center Gates
Escape Door ·        RH 30” Wide

·        Pressure Latch-Cast Aluminum

 Escape Door ·        LH Side

·        Up to 48” Wide

·        Access Hole to Latch from insude
Rear Gate ·        Single Swing Gate w/ Slider Door

·        Five (5) HD Extruded Hinges w/ Replaceable Brass Bushings and Stainless Steel Bolt

·        Cam Latch w/ Safety Chain

·        Two Top Air Gaps

 Rear Gate ·        Double Swing (Both Ways) w/ Slider Door

·        Roll Up Rear Door

·        Double Rear Doors

·        Full Rear Door (No Slider Door or Air Gaps)
Side Walls ·        1/8” Extruded 6005A Panels

·        1”x2-1/2” Side Posts on 16” Center

·        1”x5” Side Posts at Gate Locations, Front and Rear of Subframe, Horizontal over Subframe, Directly Behind Drop Sheet

·        Two (2) Top Air Gaps – Approx. 5-1/2” Wide

 Side Walls ·        Air Gaps per Customer Request
Floor ·        Traction Floor – Extruded 1-3/4”x8” Interlocking Floor ·        Crimped Extruded Floor

·        Diamond Tread w/ V Crimps

·        Double Deck Floor
Calf Gate ·        Swing Down – 1 Piece Calf Gate ·        2 Piece Side Swing w/ Center Post
Axles ·        Two (2) Dexter 3,500# on 12’ – 14’ Trailers, Electric Hydraulic/Brakes, Grease Hubs, ST235/75Rx16 Tires, Steel Wheels

·        Two (2) Dexter 8,000# on 28’-34’ Trailers Electric Hydraulic/Brakes, Grease Hubs, 235/75Rx17.5 Tires, Steel Wheels

·        Two (2) Dexter 10,000# on 36’ – 40’ Trailers Electric/Hydraulic Brakes, Grease Hubs 235/75Rx17.5 Tires, Steel Wheels

 Axles ·        Three (3) Axles

·        Electirc/Hydraulic Brakes

·        Disc Brakes

·        Oil Bath Hubs

·        Easy Lube Hubs

·        Chrome Hub and Nut Covers

·        Aluminum Wheels

·        Stainless Steel Simulators

·        14 Ply Tires
Fenders ·        8” Board Fender on 7’ Wide

·        5” Smooth Fender on 7’ 6” Wide

·        2-1/2” Smooth Fender on 8” Wide

·        Smooth Teardrop Fender on 6’ 6” Wide

 Fenders ·        Diamond Tread Teardrop on 6’ 6” Wide
Step/Tie Rails Step/Tie Rails ·        5” Solid Step Rail w/ Anti-Skid Tape

·        Open Tube Step/Tie Rail
Vents ·        Two (2) Top 5-1/2” Air Gaps Vents ·        Multiple Air Gaps per Customer Request

·        Optional Bottom 3” Air Gap – No Charge

·        Drop Sheets Vents w/ Cover Door and Bars

·        Gooseneck Vent w/ Cover Door and Bars

·        Two Way Roof Vents

·        Sliding Corner Vents on Full Width Trailers

·        Drop Sheet Vent Deflector
Vent Covers Vent Covers ·        Lexan in Any or All Side and Rear Air Gaps

·        Hinged Aluminum Cover Panels

·        Non-Hinged Panels Attached w/ Screws
Lights ·        One (1) Interior Light w/ Switch on 20’ Trailer

·        Two (2) LED Stop/Turn/Tail Lights on Rear

·        2” Round LED Rear Marker Lights

·        ¾” LED Button Side and Front Marker Lights

o   Three Center Front Marker Lights

o   Three Marker Lights Down Each Side

 Lights ·        Two (2) Back Up Lights – 6” LED Oval

·        Two (2) Rear Load Lights – 6” LED Oval

·        Side Roof Rail Lights

·        Above or Below Fender Marker/Turn Lights

·        Additional ¾” LED Side Marker Lights